Nissan Maxima Workshop Manual 2006 (9) PDF | Page 16

CL-16
CLUTCH DISC, CLUTCH COVER AND FLYWHEEL
Revision: October 2006 2006 Maxima
CLUTCH DISC, CLUTCH COVER AND FLYWHEEL PFP:30100
Removal and Installation
ECS009SU
CAUTION:
? Do not clean the clutch disc with solvent.
? When installing, do not get grease from the main drive shaft onto the clutch disc friction surface.
? If the flywheel needs to be removed, align the dowel pin with the smallest hole of flywheel. Refer to
EM-144, "
Dowel Pin Alignment" .
REMOVAL
1. Remove the manual transaxle from the vehicle. Refer to MT-16, "Removal and Installation" .
2. Evenly loosen the bolts holding the clutch cover, using power tool. Then remove the clutch cover and the
clutch disc.
INSTALLATION
Installation is in the reverse order of removal.
? Insert Tool into clutch disc hub when installing clutch cover and
disc.
? Be careful not to allow grease to contaminate clutch facing.
? Tighten the clutch cover bolts in the numerical order as shown,
in two steps.
1. Flywheel 2. Clutch disc 3. Clutch cover
4. Washer 5. Main drive shaft
WCIA0147E
First step : 10 ? 20 Nm (1.0 ? 2.0 kg-m, 7 ? 14 ft-lb)
Final step : 35 ? 44 Nm (3.5 ? 4.5 kg-m, 26 ? 32 ft-lb)
SCL600-C