Nissan Maxima Workshop Manual 2005 (36) PDF | Page 2

SB-2
PRECAUTIONS
Revision: July 2005 2005 Maxima
PRECAUTIONS PFP:00001
Precautions for Supplemental Restraint System (SRS) ?AIR BAG? and ?SEAT
BELT PRE-TENSIONER?
EHS0010Z
The Supplemental Restraint System such as ?AIR BAG? and ?SEAT BELT PRE-TENSIONER?, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRS and SB section of this Service Man-
ual.
WARNING:
? To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.
? Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.
? Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.
Precaution for Seat Belt Service EHS00110
CAUTION:
? Before removing the seat belt pre-tensioner assembly, turn the ignition switch off, disconnect the
battery ground cable and wait at least 3 minutes.
? Do not use electrical test equipment for seat belt pre-tensioner connector.
? After replacing or reinstalling seat belt pre-tensioner assembly, or reconnecting seat belt pre-ten-
sioner connector, check the system function. Refer to SRS-21, "
SRS Operation Check" .
? Do not use disassembled buckle or seat belt assembly.
? Replace anchor bolts if they are deformed or worn out.
? Never oil tongue and buckle.
? If any component of seat belt assembly is questionable, do not repair. Replace the whole seat belt
assembly.
? If webbing is cut, frayed, or damaged, replace seat belt assembly.
? When replacing seat belt assembly, use a genuine NISSAN seat belt assembly.