Nissan 350Z Workshop Maunual 2006 (11) PDF | Page 2

Revision: 2005 August 2006 350Z
Precautions for Supplemental Restraint System (SRS) ?AIR BAG? and ?SEAT
The Supplemental Restraint System such as ?AIR BAG? and ?SEAT BELT PRE-TENSIONER?, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRS and SB section of this Service Man-
? To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.
? Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.
? Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.
Precautions for Battery Service NBS0001N
Before disconnecting the battery, lower both the driver and passenger windows. This will prevent any interfer-
ence between the window edge and the vehicle when the door is opened/closed. During normal operation, the
window slightly raises and lowers automatically to prevent any window to vehicle interference. The automatic
window function will not work with the battery disconnected.
Precautions for Liquid Gasket NBS0001O
? After removing mounting bolts and nuts, separate the mating
surface using seal cutter [SST] and remove old liquid gasket
Be careful not to damage the mating surfaces.
? Tap seal cutter to insert it, and then slide it by tapping on the
side as shown in the figure.
? In areas where seal cutter [SST] is difficult to use, use plastic
hammer to lightly tap the parts, to remove it.
If for some unavoidable reason tool such as screwdriver is
used, be careful not to damage the mating surfaces.
1. Using scraper, remove old liquid gasket adhering to the liquid
gasket application surface and the mating surface.
? Remove liquid gasket completely from the groove of the liquid
gasket application surface, mounting bolts, and bolt holes.
2. Wipe the liquid gasket application surface and the mating sur-
face with white gasoline (lighting and heating use) to remove
adhering moisture, grease and foreign materials.