Honda CRV Shop Manual 1997 2002 (4) PDF | Page 6

????
(QJLQH?(OHFWULFDO 6WDUWLQJ?6\VWHP
6WDUWHU?&LUFXLW?7URXEOHVKRRWLQJ??FRQWG?
$OWHUQDWH?3URFHGXUH??FRQWG?
?? Check the following items in the order listed until
you find the open circuit.
? Check the BLK/WHT wire and connectors between
the under-dash fuse/relay box and the ignition
switch, and between the under-dash fuse/relay box
and the starter.
? Check the ignition switch (see page 11-3).
? Check the transmission range switch and connector
(A/T).
? Check the starter cut relay (A/T).
?? Check the engine speed while cranking the engine.
,V?WKH?HQJLQH?VSHHG?DERYH?????USP??PLQ ?"
<HV Go to step 8.
1R Replace the starter, or remove and
disassemble it, and check for the following
until you find the cause.
? Excessively worn starter brushes
? Open circuit in commutator brushes
? Dirty or damaged helical splines or drive gear
? Faulty drive gear clutch
?? Check the cranking voltage and current draw.
,V?FUDQNLQJ?YROWDJH?JUHDWHU?WKDQ?RU?HTXDO?WR?????9?
?([FHSW?.(??.*??.5??.6??.=?PRGHOV???????9??.(??.*??
.5??.6??.=?PRGHOV??DQG?FXUUHQW?GUDZ?OHVV?WKDQ?RU?
HTXDO?WR?????$??.??$???([FHSW?.(??.*??.5??.6??.=?
PRGHOV???.??$??HQJLQHV???????$??.??$??HQJLQH???????
$??.??$???.(??.*??.5??.6??.=?PRGHOV??HQJLQH??"
<HV Go to step 9.
1R Replace the starter, or remove and
disassemble it, and check for the following
until you find the cause.
? Open circuit in starter armature commutator
segments
? Starter armature dragging
? Shorted armature winding
? Excessive drag in engine
?? Remove the starter, and inspect its drive gear and
the flywheel or torque converter ring gear for
damage. Replace any damaged parts.?
6WDUWHU?6ROHQRLG?7HVW
.(??.*??.5??.6??.=?PRGHOV
?? Check the hold-in coil for continuity between the S
terminal (A) and the armature housing (ground).
There should be continuity.
? If there is continuity, go to step 2.
? If there is no continuity, replace the solenoid.
?? Check the pull-in coil for continuity between the S
terminal (A) and M terminal (B). There should be
continuity.
? If there is continuity, the solenoid is OK.
? If there is no continuity, replace the solenoid.