Honda CRV Shop Manual 1997 2002 (4) PDF | Page 49

&UXLVH?&RQWURO
?????
$FWXDWRU?&DEOH?$GMXVWPHQW
?? Check that the actuator cable (A) moves smoothly
with no binding or sticking.
?? Measure the amount of movement of the output
linkage (B) until the engine speed starts to
increase. At first, the output linkage should be
located at the fully closed position (C). The free
play (D) should be 3.75 0.5 mm (0.15 0.02 in.).
?? If the free play is not within specs, loosen the
locknut (E), and turn the adjusting nut (F) until the
free play is as specified, then retighten the locknut.
&OXWFK?3HGDO?3RVLWLRQ?6ZLWFK?7HVW
?? Disconnect the 2P connector from the clutch pedal
position switch (A).
?? Remove the clutch pedal position switch.
?? Check for continuity between the terminals
according to the table.
? If the continuity is not as specified, replace the
clutch pedal position switch.
? If OK, install the clutch pedal position switch and
adjust the pedal height (see page 12-4).
Terminal side of
male terminals