Honda CRV Shop Manual 1997 2002 (4) PDF | Page 46

?????
(QJLQH?(OHFWULFDO &UXLVH?&RQWURO
0DLQ?6ZLWFK?7HVW?5HSODFHPHQW
?? Detach the three clips (A), to create clearance
between the dashboard and dashboard panel.
?? Release the clips of the main switch, and push the
main switch (B) out of the panel, then disconnect
the 5P connector (C) from the main switch.
?? Check for continuity between the terminals in each
switch position according to the table. If there is no
continuity, replace the illumination bulbs (D) or the
switch.
6HW?5HVXPH?&DQFHO?6ZLWFK?7HVW?
5HSODFHPHQW
?? Remove the two screws, then remove the switch.
?? Check for continuity between the terminals in each
switch position according to the table.
? If there is continuity, and it matches the table, but
switch failure occurred on the cruise control unit
input test, check and repair the wire harness on the
switch circuit.
? If there is no continuity in one or both positions,
replace the switch.
Terminal side of
male terminals
Terminal side of
male terminals