Honda CRV Shop Manual 1997 2002 (4) PDF | Page 43

&UXLVH?&RQWURO
?????
&UXLVH?&RQWURO?&RPPXQLFDWLRQ?&LUFXLW?7URXEOHVKRRWLQJ
?? Start the engine.
?? Turn on the cruise control main switch, then drive
the vehicle to speeds over 25 mph (40 km/h) with
the cruise control.
'RHV?WKH?FUXLVH?FRQWURO?RSHUDWH"
<HV Go to step 3.
1R Check the cruise control unit (see page 04-
44) or cruise control actuator.?
?? Turn the ignition switch OFF.
?? Disconnect the negative cable from the battery.
?? Disconnect Powertrain Control Module (PCM)
connector D (17P) and cruise control unit 14P
connector.
?? Check for continuity between PCM connector
terminal D12 and body ground.
Wire side of female terminals
,V?WKHUH?FRQWLQXLW\"
<HV Repair short to ground in the wire between
PCM connector terminal D12 and the cruise
control unit 14P connector terminal No. 8.?
1R Go to step 7.
?? Reconnect PCM connector D (17P) and the cruise
control unit 14P connector.
?? Connect the negative cable to the battery.
?? Connect a voltmeter between cruise control unit
14P connector terminal No. 8 and body ground.
Test-drive the vehicle at speeds over 25 mph (40
km/h) with the cruise control set, and watch the
voltmeter.
Wire side of female terminals
,V?WKHUH?DERXW???9"
<HV Go to step 10.
1R Substitute a known-good cruise control unit. If
the system works properly, replace the cruise
control unit.?
??? Connect a voltmeter between PCM connector
terminal D12 and body ground. Drive the vehicle at
speeds over 25 mph (40 km/h) with the cruise
control set, and watch the voltmeter.
Wire side of female terminals
,V?WKHUH?DERXW???9"
<HV Check for loose connectors of the BLU/ORN
wire between the cruise control unit and the
PCM. If necessary replace the PCM and
recheck (see page 11-4).?
1R Repair open in the wire between PCM
connector terminal D12 and the control unit
14P connector terminal No. 8.?