Honda CRV Shop Manual 1997 2002 (4) PDF | Page 41

&UXLVH?&RQWURO
?????
6\PSWRP?7URXEOHVKRRWLQJ?,QGH[
NOTE:
? The numbers in the table show the troubleshooting sequence.
? Before troubleshooting.
? check the No. 10 (7.5A) and No. 4 (10A) fuses in the under-dash fuse/relay box, and the No. 7 (15A) fuse in the under-
hood fuse/relay box.
? check that the horn sounds.
? check the tachometer to see if it works properly.
(cont?d)
Cruise control cannot be set Check main switch (see page 04-46)
Check SET/RESUME/CANCEL switch (see page 04-46)
Test brake pedal position switch (see page 22A-99) and check its
adjustment (see page 19A-5)
Test clutch pedal position switch (see page 04-49) and check its
adjustment (M/T) (see page 12-4)
Check transmission range switch (A/T) (see page 14-168)
Check control unit (see page 04-44)
Poor ground: G101 (A/T),
G501 (M/T)
Open circuit, loose or
disconnected terminals:
LT GRN, GRN/YEL,
GRY/RED, BLU, WHT/
GRN (A/T), LT BLU
(M/T), BLU/WHT
Cruise control can be set but
indicator light does not go on
Check cruise control indicator bulb in gauge assembly (see page
22A-73)
Check control unit (see page 04-44)
Poor ground: G501
Open circuit, loose or
disconnected terminals:
YEL, BLU/YEL
Cruise speed is noticeably higher
or lower than what was set
Check Vehicle Speed Sensor (VSS) (see page 22A-75)
Check actuator (see page 04-47)
Check control unit (see page 04-44)
Excessive overshooting or
undershooting when trying to set
speed
Check actuator (see page 04-47)
Check Vehicle Speed Sensor (VSS) (see page 22A-75)
Check control unit (see page 04-44)
Speed fluctuation on a flat road
with cruise control set
Check Vehicle Speed Sensor (VSS) (see page 22A-75)
Check actuator (see page 04-47)
Check control unit (see page 04-44)
Vehicle does not decelerate or
accelerate accordingly when
SET/RESUME/CANCEL button is
pushed
Check SET/RESUME/CANCEL switch (see page 04-46)
Check control unit (see page 04-44)
Open circuit, loose or
disconnected terminals:
GRY/RED, LT GRN/BLK
Set speed not cancelled (engine
rpm stays high) when clutch
pedal is pushed (M/T)
Test clutch pedal position switch (see page 04-49) and check its
adjustment (see page 12-4)
Check control unit (see page 04-44)
Short to ground in the LT
BLU wire
Set speed not cancelled when
shift lever is moved to Neutral
position (A/T)
Check transmission range switch (see page 14-168)
Check control unit (see page 04-44)
Short to ground in the WHT/
GRN wire
Set speed not cancelled when
brake pedal is pushed
Test brake pedal position switch (see page 22A-99) and check its
adjustment (see page 19A-5)
Check control unit (see page 04-44)
Open circuit, loose or
disconnected terminals:
WHT/BLK